Loading ...
Loading ...
Loading ...
ELECTRICAL SYSTEM 16-49
Electric Starter System
Starter Motor Installation
NOTICE
Do not tap the starter motor shaft or body. Tapping
the shaft or body could damage the motor.
•
When installing the starter motor, clean the starter mo-
tor legs [A] and crankcase [B] where the starter motor is
grounded.
•
Install the starter motor cable [A] as shown.
[B] Upward
•
Tighten:
Torque - Starter Motor Cable Terminal Nut [C]: 5.9 N·m (0.60
kgf·m, 52 in·lb)
•
Slide back the rubber cap to the original position.
•
Replace the O-ring [A] with a new one.
•
Apply grease to the O-ring.
•
Tighten:
Torque - Starter Motor Mounting Bolts: 9.8 N·m (1.0 kgf·m,
87 in·lb)
•
Install the water hose and pipe (see Water Pump Instal-
lation in the Cooling System chapter).
Starter Motor Disassembly
•
Remove the starter motor (see Starter Motor Removal).
•
Take off the starter motor through bolts [A] and remove
the both end covers [B].
•
Pull out the armature [A] out of the yoke [B].
NOTE
○
Do not remove the circlip [C] from the shaft.
Loading ...
Loading ...
Loading ...