Loading ...
Loading ...
Loading ...
BRAKES 12-19
Brake Pads
Rear Brake Pad Removal
•
Remove the rear caliper with the hose installed (see Rear
Caliper Removal).
•
Remove:
Clip [A]
Pad Pin [B]
•
Remove the brake pad [C] of the jaw side from the holder
shaft [D], then remove the other pad [E].
Rear Brake Pad Installation
•
Check that the pad spring [A] and guide [B] are in place
on the caliper and holder.
•
Push the caliper piston in by hand as far as it will go.
•
Install the brake pad [A] on the piston side first, then install
the other pad on the holder shaft.
○
Fit the projections [B] of the piston side pad into the re-
cesses [C] of the caliper holder.
•
Install the pad pin while pushing the brake pad of the jaw
side lightly.
•
Install a new clip.
○
The clip must be “outside” of the pad.
•
Install the rear caliper (see Rear Caliper Installation).
WARNING
After servicing, it takes several applications of the
brake pedal before the brake pads contact the disc,
which could result in increased stopping distance
and cause an accident resulting in injury or death.
Do not attempt to ride the motorcycle until a firm
brake pedal is obtained by pumping the pedal until
the pads are against the disc.
Brake Pad Wear Inspection
•
Refer to the Brake Pad Wear Inspection in the Periodic
Maintenance chapter.
Loading ...
Loading ...
Loading ...