Loading ...
Loading ...
Loading ...
2-46 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
To move the headlight beam leftward, turn the left ad-
juster [A] clockwise and turn the right adjuster counter-
clockwise same number as the left adjuster was turned
until the beam points straight ahead.
•
To move the headlight beam rightward, turn the left ad-
juster counterclockwise and turn the right adjuster clock-
wise same number as the left adjuster was turned until
the beam points straight ahead.
•
To move the headlight beam upward, turn the both ad-
justers clockwise same number.
•
To move the headlight beam downward, turn the both ad-
justers counterclockwise same number.
NOTE
○
On high beam, the brightest points should be slightly
below horizontal with the motorcycle on its wheels and
the rider seated. Adjust the headlight to the proper an-
gle according to local regulations.
NOTE
○
For US model, the proper angle is 0.4 degrees below
horizontal. This is 50 mm (2 in.) drop at 7.6 m (25
ft) measured from the center of the headlight with the
motorcycle on its wheels and the rider seated.
50 mm (2 in.) [A]
Center of Brightest Spot [B]
7.6 m (25 ft) [C]
Height of Headlight Center [D]
Sidestand Switch Operation Inspection
•
Inspect the sidestand switch [A] operation accordance to
the following table.
Sidestand Switch Operation
Sidestand
Gear
Position
Clutch
Lever
Engine
Start
Engine
Run
Up Neutral Released Starts
Continue
running
Up Neutral Pulled in Starts
Continue
running
Up In Gear Released
Doesn’t
start
Continue
running
Up In Gear Pulled in Starts
Continue
running
Down Neutral Released Starts
Continue
running
Down Neutral Pulled in Starts
Continue
running
Down
In Gear
Released
Doesn’t
start
Stops
Down
In Gear
Pulled in
Doesn’t
start
Stops
Loading ...
Loading ...
Loading ...