Loading ...
Loading ...
Loading ...
Fuses and bulbs
Changing bulbs
Fig. 108
Boot: access to the bolt securing the
t
ail light unit.
Fig. 109 Retaining tabs on reverse side of tail
light.
Follow the steps indicated:
Check which of the bulbs is def
ectiv
e
.
Open the rear lid.
1.
2.
Remove the lid, levering the flat side of a
screwdriver into the recess
›››
Fig. 108
1
.
R
emo
v
e the bulb connector
2
.
Unscr
e
w the bolt securing the light
3
by
hand or using a scr
e
w
driver.
Remove the light from the body, gently
pulling it toward you, and place on a
clean, smooth surface.
Remove the bulb holder unlocking the
retaining tabs
›››
Fig. 109
A
.
Change the damaged bulb
.
T
o r
efit follow the steps in reverse order,
taking special care when fitting the bulb
holder. The securing tabs must click into
place.
CAUTION
Take care when removing the rear light unit
to make sur
e there is no damage to the
paintwork or any of its components.
Note
●
Make sure you hav
e a soft cloth ready to
place under the glass on the rear light unit,
to avoid any scratches.
●
For LED lights, you can only change the
turn signal and reverse light bulbs.
3.
4.
5.
6.
7.
8.
9.
Number plate light
–
Insert the flat part of a screwdriver into the
special slot and remo
ve the bulb.
–
Remove the bulb holder, by turning it until it
is free.
–
Change the bulb.
–
Replace the bulb holder, by turning it until it
fits fully.
–
Fit the light into the space and press until
you hear a “click”.
Note
Depending on how equipped the vehicle is,
the number plate lights may be LEDs. LEDs
hav
e an estimated life that exceeds than
that of the car. If a light with LEDs fails, go
to an authorised workshop for replace-
ment.
97
Loading ...
Loading ...
Loading ...