Loading ...
Loading ...
Loading ...
Opening and closing
Once the doors have been locked, they can-
not be opened again immediat
ely. This will
enabl
e you t
o check that the doors are prop-
erly closed.
If you wish, when unlocking, you can unlock
only the driver’s door, the side being un-
locked, or the entire vehicle. The necessary
adjustments can be performed in vehicles
with a driver information system
›››
page 34.
General information
If a valid key is located in the proximity of the
car
›››
Fig. 137, the Keyless Access locking
and starting system gives the key entry as
soon as one of the sensor surfaces on the
driver door handle is touched. The following
features are then available without having to
use the vehicle key actively:
●
Keyless-Entry: unlocking the vehicle using
the handle of the front driver’s door or the
softtouch/handle on the rear lid.
●
Keyless-Exit: locking the vehicle using the
sensor on the driver door handle.
●
Press & Drive: keyless starting of the engine
with the starter button
›››
page 223.
The central locking and locking systems op-
erate in the same way as a normal locking
and unlocking system. Only the controls
change.
Unlocking the vehicle is confirmed with a
double flash of the indicator lights; locking by
a single flash.
If the vehicle is locked and then all doors and
the rear lid are closed leaving the last key
used inside the vehicle and none outside, the
vehicle will not lock immediately. All the ve-
hicle's indicator lights will flash four times.
The vehicle will lock after a few seconds if
you do not open any door or the rear lid.
The vehicle will lock again after a few sec-
onds if you unlock the vehicle but fail to open
any door or boot hatch.
Unlocking and opening the doors (Key-
less-Entry)
●
Grip the driver door lever. In doing this, the
sensor surface
›››
Fig. 138
A
(arrow) on the
handl
e is t
ouched and the v
ehicle unlocks.
●
Open the door.
On vehicles with selective opening or info-
tainment system configuration, pulling the
door handle twice will unlock all doors.
In vehicles without safety system “Safe”:
closing and locking the doors (Keyless-Ex-
it)
●
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the locking sensor surface
B
(arrow) on the driver door handle. The door
that is used must be cl
osed.
In v
ehicl
es with safety system “Safe”:
closing and locking the doors (Keyless-Ex-
it)
●
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the locking sensor surface
B
(arrow) on the driver door handle. The vehicle
l
ocks with the “Saf
e” securit
y system
›››
page 128. The door that is used must be
closed.
●
Touch (twice) the sensor surface
B
(arrow)
of the driv
er door handl
e t
o lock the vehicle
without activating the “Safe” security system
›››
page 128.
Unlocking and locking the boot hatch
When the vehicle is locked, the rear lid auto-
matically unlocks on opening if there is a val-
id vehicle key in the proximity
›››
Fig. 137.
Open or close the rear lid normally.
After closing, the hatch locks automatically. If
the complete vehicle is unlocked, the rear lid
will not lock automatically after closing it.
»
131
Loading ...
Loading ...
Loading ...