Loading ...
Loading ...
Loading ...
Start and driving
thereby causing a small turn of the wheel in
the corr
ect dir
ection t
o avoid skidding
›››
.
WARNING
If the power steering does not work, you
will need much more strength t
o turn the
wheel. This has a considerable effect on
vehicle safety.
●
The power steering only works when the
engine is running.
●
Never allow the vehicle to move when the
engine is switched off.
●
Never remove the key from the ignition
while the vehicle is moving. The steering
lock could be engaged and vehicle steer-
ing would not work.
WARNING
Power-assisted steering, together with the
ESC, helps the driver to contr
ol vehicle
steering in critical situations. However, the
driver is ultimately responsible for steering
the vehicle at all times. Power-assisted
steering does not remove this responsibili-
ty.
Note
The ignition of the vehicle being towed
must be switched on t
o prevent the steering
wheel from locking and also to allow the
use of the turn signals, horn, windscreen
wipers and washers.
Control lamp
It lights up red
The electromechanical steering is damaged.
Do not continue driving. Stop the vehicle safely and
as soon as possible.
Have the steering checked immediately by a special-
ised workshop.
It lights up yellow
The operation of the electromechanical steering is
limited.
See a specialised workshop immediat
ely and have
the steering checked.
If the yellow warning lamp does not light up again af-
ter the engine is restarted and the vehicle has travel-
led a short distance, you do not need to take it to a
specialised workshop.
Or: The 12-volt battery was disconnected and has
been connected again.
Driv
e for a short time at 15-20 km/h (9-12 mph).
It flashes yellow
The steering column is tight.
Turn the wheel a little t
o both sides.
Or: Not unlocked or blocked steering column.
Remo
ve the key from the ignition and then switch the
ignition back on. If necessary, check the messages
displayed on the instrument panel display.
Do not drive on if the steering column remains
locked after the ignition has been switched on. Seek
specialist assistance.
The control lamp should light up for a few
seconds when the ignition is s
wit
ched on. It
shoul
d go out once the engine is started.
WARNING
If the warning lamps and the corresponding
messages are ignored when they light up
,
the vehicle may stall in traffic. It could case
damage to the vehicle and cause acci-
dents and severe injuries.
●
Never ignore the warning lamps or mes-
sages.
●
Stop the vehicle at the next opportunity
and in a safe place.
Run-in and economical driv-
ing
Running in a ne
w engine
The engine needs to be run-in over the first
1500 km (900 mil
es).
F
or the first 1,
000 kilometres (600 miles)
–
Do not drive at speeds of more than 2/3 the
maximum speed.
–
Do not accelerate hard.
–
Avoid high engine revolutions.
–
Do not tow a trailer.
»
245
Loading ...
Loading ...
Loading ...