Loading ...
Loading ...
Loading ...
General instrument panel
This option cannot be deactivated in models
destined f
or countries in which the second
speed must al
w
ays be visible.
Start-Stop operating display.
Updated information relating to the status is
displayed on the instrument panel
›››
page 259.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning l
amps on page 109.
WARNING
Even though outside temperatures are
above fr
eezing, some roads and bridges
may be icy.
●
At outside temperatures above +4°C
(+39°F), even when the “ice crystal sym-
bol” is not visible, there may still be patch-
es of ice on the road.
●
Do not rely on the outside temperature
indicator!
Note
●
Different v
ersions of the instrument panel
are available and therefore the versions
and instructions on the display may vary. In
the case of displays without warning or in-
formation texts, faults are indicated exclu-
sively by the warning lamps.
●
When sever
al warnings are active at the
same time, the symbols are shown succes-
sively for a few seconds and will stay on
until the fault is rectified.
Compass*
Fig. 121
Magnetic zones
The compass does not require calibration in
v
ehicl
es f
or which the navigation system was
mounted at the factory. The option compass
disappears.
The compass in vehicles in which the naviga-
tion system was not mounted at the factory,
is permanently and automatically calibrated.
If electronic or metal accessories (mobile
phone, television) are subsequently mounted
in the vehicle, the compass should be recali-
brated manually.
Adjusting the magnetic zone
●
Switch the ignition on.
●
Select the Settings menu followed by the
option Compass and Zone.
●
Select the magnetic zone corresponding to
the position of the vehicle
›››
Fig. 121.
●
Adjust and confirm the magnetic zone
(1-15).
Calibrating compass
To calibrate the compass you must be in one
of the valid magnetic zones with sufficient
space to be able to trace a circumference
with the vehicle.
●
Switch the ignition on.
●
Select the Settings menu followed by the
option Compass and Calibrate.
●
Confirm the message Describe a com-
plete circumference to calibrate the
compass with OK
and then trace a complete
cir
cumf
er
ence driving at approximately
10 km/h (6 mph).
When the corresponding cardinal point is dis-
played, the calibration is complete.
Service interval display
The service indication is shown on the dash
panel displ
ay
›
›
›
Fig. 120
4
.
»
107
Loading ...
Loading ...
Loading ...