Loading ...
Loading ...
Loading ...
Steps
1. Click Access Control → Advanced Funcon → Device
Parameter .
2.
In the device list on the
le, click to expand the door, select a
card reader and you can edit the card reader's parameters on
the right.
3. Edit the card reader basic parameters in the Basic Informaon
page.
Note
The displayed parameters may vary for dierent access control
devices. There are part of parameters listed as follows. Refer to
the user manual of the device for more details.
Name
Edit the card reader name as desired.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less
than the set value, the card swiping is invalid. You can set it
as 0 to 255.
Alarm of Max. Failed
Aempts
Enable to report alarm when the card reading aempts
reach the set value.
Card Reader Type/Card Reader Descripon
Get card reader type and descripon. They are read-only.
4. Oponal: Some of the following parameters are not listed in
the Basic Informaon page, click Advanced to edit the
parameters.
Enable Card Reader
If enabling the
funcon, user can present card on the card
reader. If disabling the funcon, the card reader for entrance
cannot be used.
OK LED Polarity/Error LED Polarity/Buzzer Polarity
Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of
main board according to the card reader parameters.
Generally, adopts the default
sengs.
Buzzing Time
Set the card reader buzzing me. The available me ranges
from 0 to 5,999s. 0 represents connuous buzzing.
Max. Interval When Entering PWD
When you inpung the password on the card reader, if the
interval between pressing two digits is larger than the set
value, the digits you pressed before will be cleared
automacally.
Tampering Detecon
Enable the an-tamper detecon for the card reader.
Communicate with Controller Every
When the access control device cannot connect with the
card reader for longer than the set me, the card reader will
turn
oine automacally.
Fingerprint Recognion Level
57
Loading ...
Loading ...
Loading ...