Loading ...
Loading ...
Loading ...
Setting up the printer to fax
SETTING UP THE FAX FUNCTION
• Some connection methods are applicable only in some countries or regions.
• If the fax function is enabled and not fully set up, then the indicator light may blink red.
• If you do not have a TCP/IP environment, then use the control panel to set up fax.
WWaarrnniinngg:: To avoid loss of data or printer malfunction, do not touch cables or the printer in the area
shown while actively sending or receiving a fax.
Using the fax setup wizard in the printer
• The setup wizard is available only if analog fax is not set up.
• This wizard only sets up the analog fax. To setup other fax modes, go to SSeettttiinnggss >> FFaaxx >> FFaaxx SSeettuupp.
• These instructions apply only to some printer models.
• Before using the wizard, make sure that the printer firmware is updated. For more information, see Using the fax
setup wizard in the printer.
1. From the home screen, touch FFaaxx.
2. Touch SSeett uupp nnooww.
3. Type the fax name, and then touch NNeexxtt.
4. Enter the fax number and then touch DDoonnee.
Using the Settings menu in the printer
1. From the control panel, navigate to:
SSeettttiinnggss > FFaaxx > FFaaxx SSeettuupp > GGeenneerraall FFaaxx sseettttiinnggss
For non-touch-screen printer models, press
to navigate through the settings.
2. Configure the settings.
Xerox
®
B225/B235 Multifunction Printer User Guide 39
Set up, install, and configure
Loading ...
Loading ...
Loading ...