Loading ...
Loading ...
Loading ...
Symptom Possible cause Repair order
When outside is bright, neither tail
lamps nor headlamps turn off by
auto light operation.
Auto light sensor check Check auto light sensor input signal.
(With CONSULT-II)
See “AUTO LIGHT SENSOR” in DATA MONITOR
mode. When auto light sensor in stuck by light:
More than 3V
When auto light sensor is not stuck by light:
Approx. 0.5V
(Without CONSULT-II)
Check voltage between smart entrance control unit ter-
minal 7 (W/G) and ground. Refer to smart entrance
control unit. (EL-378)
SEL107X
Bulb Replacement
NAEL0261
The headlamp is a semi-sealed beam type which uses a replace-
able halogen bulb. The bulb can be replaced from the engine com-
partment side without removing the headlamp body.
I Grasp only the plastic base when handling the bulb. Never
touch the glass envelope.
1. Disconnect the battery cable.
2. Disconnect the harness connector from the back side of the
bulb.
3. Pull off the rubber cap.
4. Remove the headlamp bulb carefully. Do not shake or rotate
the bulb when removing it.
5. Install in the reverse order of removal.
CAUTION:
Do not leave headlamp reflector without bulb for a long period
of time. Dust, moisture, smoke, etc. entering headlamp body
may affect the performance of the headlamp. Remove head-
lamp bulb from the headlamp reflector just before a replace-
ment bulb is installed.
Aiming Adjustment
NAEL0262
Before performing aiming adjustment, check the following.
For details, refer to the regulations in your own country.
1) Keep all tires inflated to correct pressures.
2) Place vehicle flat surface.
3) See that there is no-load in vehicle (coolant, engine oil filled up
to correct level and full fuel tank) other than the driver (or
equivalent weight placed in driver’s position).
GI
MA
EM
LC
EC
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
IDX
HEADLAMP (FOR USA)
Trouble Diagnoses (Cont’d)
EL-43
Loading ...
Loading ...
Loading ...