Loading ...
Loading ...
Loading ...
Symptom Possible cause Repair order
Retained power operation does not
operate properly.
1. RAP signal circuit
2. Driver or passenger side door
switch circuit
3. Smart entrance control unit
1. Check RAP signal.
a. (With CONSULT-II)
I Check RAP signal with CONSULT-II.
Use “WORK SUPPORT” mode, “RETAINED PWR” in
“SMART ENTRANCE”. (Refer to EL-278.)
I Check RAP signal with CONSULT-II.
Use “ACTIVE TEST” mode, “RETAINED PWR” in
“SMART ENTRANCE”.
(Refer to EL-277.)
If NG, go to the step b. below.
b. Verify 12 positive voltage from smart entrance con-
trol unit terminal 46 is present at terminal 2 of power
window relay:
I Within 45 seconds after ignition switch turns off.*1
I When front door LH and RH is closed.
2. Check the following.
a. Harness between smart entrance control unit and
driver or passenger side door switch for short circuit
b. Driver or passenger side door switch ground circuit
c. Driver or passenger side door switch
3. Check smart entrance control unit. (EL-378)
Passenger side power window can-
not be operated using power win-
dow main switch but can be oper-
ated by passenger side power win-
dow switch.
1. Front power window main
switch
1. Check power window main switch. (EL-283)
Rear LH power window cannot be
operated using power window main
switch but can be operated by rear
LH power window switch.
1. Front power window main
switch
1. Check power window main switch. (EL-283)
Rear RH power window cannot be
operated using power window main
switch but can be operated by rear
RH power window switch.
1. Front power window main
switch
1. Check power window main switch. (EL-283)
*1: RAP signal’s period can be changed by CONSULT-II. (EL-278)
POWER WINDOW
Trouble Diagnoses (Cont’d)
EL-280
Loading ...
Loading ...
Loading ...