Loading ...
Loading ...
Loading ...
DOOR LOCK/UNLOCK SWITCH LH CHECK
=NAEL0397S06
1 CHECK DOOR LOCK/UNLOCK SWITCH INPUT SIGNAL
With CONSULT-II
Check door lock/unlock switch (“LOCK SW DR/AS”/“UNLK SW DR/AS”) in “DATA MONITOR” mode with CONSULT-II.
SEL341W
Without CONSULT-II
1. Remove key from ignition switch.
2. Check the signal between smart entrance control unit harness connector M122 terminal 33 (BR) and ground with an
oscilloscope when door lock/unlock switch is turned “LOCK” or “UNLOCK”.
3. Make sure signals shown in the figure below can be detected during the first 10 sec. just after door lock/unlock switch
is turned to “LOCK” or “UNLOCK”.
SEL396Y
Refer to wiring diagram in EL-315.
OK or NG
OK © Door lock/unlock switch is OK.
NG © Check the following.
I Ground circuit for each front power window switch
I Harness for open or short between each front power window switch and smart
entrance control unit connector
If above systems are normal, replace the front power window switch.
GI
MA
EM
LC
EC
FE
CL
MT
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
IDX
REMOTE KEYLESS ENTRY SYSTEM
Trouble Diagnoses (Cont’d)
EL-329
Loading ...
Loading ...
Loading ...