Loading ...
Loading ...
Loading ...
System Description
=NAEL0365
OPERATIVE CONDITION
NAEL0365S01
The drive position can be set in 2 ways, manually and automatically.
Manual Operation
NAEL0365S0101
The driver’s seat can be adjusted for sliding, reclining, front cushion height and rear cushion height with the
LH power seat switches. The manual operation can be adjusted with the IGN key in any position.
Automatic Operation
NAEL0365S0102
The driver’s seat is adjusted to the proper positions for the driver automatically, in 3 different ways: MEMORY
AUTOMATIC SET, AUTOMATIC EXITING SETTING and AUTOMATIC SET RETURN. (Automatic Drive Posi-
tioner = ADP)
CONDITIONS INHIBITING AUTOMATIC OPERATION
NAEL0365S02
Automatic memory setting procedures are suspended under any of the following conditions:
1) When vehicle speed is more than 7 km/h (4 MPH).
2) When driver’s side power seat switch is turned on.
3) When any two of the switches (set switch and memory switches 1 and 2) are turned ON.
4) When cancel switch is turned on.
5) When selector lever is in any position other than “P”.
6) When ignition switch is turned to “START” position.
(Operation resumes when ignition switch is returned to “ON”.)
7) When detention switch malfunction is detected:
I Detention switch failure is sensed when detention switch remains off for at least 2 seconds at a vehicle
speed of greater than 7 km/h (4 MPH).
FAIL-SAFE SYSTEM
NAEL0365S03
Output Failure
NAEL0365S0301
When the ignition switch is in the ON position, if any of the parts (indicated in the following chart) move more
than the specified amount within a period “T2” when no “ON” input is sent from any of the switches (indicated
in the following chart), or an output from the automatic drive positioner is not produced, an output failure is
sensed. Motor operation will be suspended automatically, and all automatic operations will be ineffective. (In
this case, the motor will not operate manually.)
OPERATED PORTION T2 Allowable measurement
Seat sliding Approx. 2.5 sec. Within 6 mm (0.24 in)
Seat reclining Same as above Change angle within 1°
Absolving
NAEL0365S0302
When moving selector lever back to “P” position after having moved it to any position except “P”, fail-safe
operation will be canceled.
INITIALIZATION
NAEL0365S04
After reconnecting battery cable, perform initialization procedureAor B. If initialization has not been performed,
automatic drive positioner will not operate.
PROCEDURE A
1) Insert key in the ignition key cylinder. (Ignition switch is in “OFF” position.)
2) Open , close , open driver side door. (Do not perform with the door switch operation.)
3) End
PROCEDURE B
1) Drive the vehicle at more than 25 km/h (16 MPH).
2) End
AUTOMATIC DRIVE POSITIONER
System Description
EL-214
Loading ...
Loading ...
Loading ...