Loading ...
Loading ...
Loading ...
CONSULT-II Application Items
NAEL0455
“RETAINED PWR”
NAEL0455S01
Data Monitor
NAEL0455S0101
Monitored Item Description
IGN ON SW Indicates [ON/OFF] condition of ignition switch.
DOOR SW-DR Indicates [ON/OFF] condition of front door switch LH.
DOOR SW-AS Indicates [ON/OFF] condition of front door switch RH.
Active Test
NAEL0455S0102
Test Item Description
RETAINED PWR
This test is able to supply RAP signal (power) from smart entrance control unit to power
window system, power sunroof system. Those systems can be operated when turning on
“RETAINED PWR” on CONSULT-II screen even if the ignition switch is tuned OFF.
NOTE:
During this test, CONSULT-II can be operated with ignition switch “OFF” position.
“RETAINED PWR” should be turned “ON” or “OFF” on CONSULT-II screen when
ignition switch is ON. Then turn ignition switch OFF for checking retained power
operation. CONSULT-II might be stuck if “RETAINED PWR” is turned “ON” or “OFF”
on CONSULT-II screen when ignition switch is OFF.
Work Support
NAEL0455S0103
Work Item Description
RETAINED PWR SET
RAP signal’s power supply period can be changed by mode setting. Selects RAP signal’s
power supply period between three steps.
I MODE 1 (45 sec.)/MODE 2 (OFF)/MODE 3 (2 min.)
Trouble Diagnoses
NAEL0456
Symptom Possible cause Repair order
Power sunroof cannot be operated
using any switch.
1. 7.5A fuse, 40A fusible link and
M145 circuit breaker
2. Power window relay ground cir-
cuit
3. Sunroof motor ground circuit
4. Power window relay
5. Sunroof motor circuit
6. Sunroof switch
7. Sunroof switch circuit
8. Sunroof motor
1. Check 7.5A fuse [No. 11, located in fuse block
(J/B)], 40A fusible link (letter f, located in fuse and
fusible link box) and M145 circuit breaker. Turn igni-
tion switch “ON” and verify battery positive voltage is
present at terminals 2 and 3 of power window relay
and terminal 1 of sunroof motor.
2. Check power window relay ground circuit.
3. Check sunroof motor ground circuit.
4. Check power window relay.
5. Check the wire between power window relay and
sunroof motor.
6. Check sunroof switch.
7. Check harness between sunroof switch and sunroof
motor.
8. Check sunroof motor.
Power sunroof cannot be operated
using one of the sunroof switches.
1. Sunroof switch
2. Sunroof switch circuit
1. Check sunroof switch.
2. Check the harness between sunroof motor and sun-
roof switch.
POWER SUNROOF
CONSULT-II Application Items
EL-206
Loading ...
Loading ...
Loading ...