Loading ...
Loading ...
Loading ...
WARNING
The automatic driving lamp control (position only operates as a sup-
port and does not release the driver from his responsibility to check the
light and, if necessary, to switch on the light depending on the prevailing
light conditions.
CAUTION
Poorer visibility is detected by a sensor mounted below the windscreen in the
holder of the inside mirror or in the control panel, if required. Do not cover the
sensor - the system can be affected.
Note
The setting (activate/deactivate) of the automatic driving light control during
rain is stored (depending on the Infotainment type) in the active user account
personalisation » page 55.
FullLED headlights
The Full LED headlights (hereinafter referred to as just system) use the journey
data to automatically ensure the best possible light cone in front of the vehicle.
The system operates automatically in the following modes: Urban, extra-urban,
motorway and bad weather.
A component of the system is the static side light. This light is used in some
light modes, e.g. for bend illumination during reversing.
The system works as long as the light switch is in position
.
WARNING
If there is a system malfunction the headlights are automatically lowered to
the emergency position, which prevents a possible dazzling of oncoming
traffic. This reduces the cone of light in front of the vehicle. Seek help from
a specialist garage.
Light Assist
Fig. 60 Installation location versions of the sensor / system on/off
The system automatically switches the high beam on/off in accordance with
the existing traffic (other vehicles) and environmental conditions (e.g. driving
through a lit village).
The high beam on/off is controlled by a sensor or a camera » Fig. 60.
The system can be activated/deactivated in Infotainment in the menu
/
→ →
light
→
Light Assist
,
Conditions for the system function
The system is activated.
The light switch is in the position
.
The vehicle speed is over 60 km/h or for some countries more than 40
km/h.
The windscreen is clean in the sensor area.
Switch on the system
›
Push the lever into the sprung position
A
» Fig. 60. The following indicator
light lights up in the instrument cluster display.
Switch off the system
›
If the high beam is switched on automatically, move the lever into the sprung
position
B
. The warning light goes out. The high beam turns off.
›
If the high beam is is not switched on automatically, move the lever into the
sprung position
A
. The warning light goes out. The high beam turns on.
The high beam switches off automatically when the speed falls below 30 km/h
(but the system remains switched on).
71
Lights and visibility
Loading ...
Loading ...
Loading ...