Loading ...
Loading ...
Loading ...
Fig. 344
Removing the plug / installing the light
Read and observe and on page 290 first.
Removing
›
Open the boot lid.
›
Open the respective cap
A
or
B
in the direction of arrow
1
» Fig. 343. The
pop-up versions for the right cap
B
are different depending on equipment
fitted.
›
Remove screw
C
in the direction of arrow
2
. The screw remains in the
body, which is fitted with an anti-fall device.
›
Hold the light and carefully remove in the direction of arrow
3
.
›
Press the latch
D
on the holder in the direction of the arrow
4
» Fig. 344.
›
Press the securing lug in the direction of arrow
5
and pull out the plug in the
direction of arrow
6
.
Fitting
›
Slide the plug in the opposite direction of the arrow
6
» Fig. 344 into the
light.
›
Secure the latch
D
in the opposite direction to arrow
4
.
›
Carefully insert the lamp with the strips
F
into the guide grooves
G
in the
body and the lamp to the stop in the direction of the arrow
7
» .
›
Tighten screw
C
in the opposite direction to arrow
2
» Fig. 343.
›
Close the cap
A
or.
B
in the opposite direction of arrow
1
and insert into
the respective opening.
CAUTION
■
Ensure that when re-inserting the light the wiring harness between the body
and the light is not jammed and the seal
E
» Fig. 344 is correctly inserted -
Otherwise there is a risk of water ingress and damage to the electrical installa-
tion.
■
Ensure that the vehicle paintwork and the tail lamp are not damaged when
removing and installing the tail lamp.
Changing the bulbs in the taillight (turn signal and reversing lights)
Fig. 345
Outer part of the lamp/holder with bulbs
Read and observe and on page 290 first.
›
Unlock the bulb holder at the areas marked with arrows » Fig. 345 and re-
move from the light.
›
Remove the faulty bulb from the holder in the direction of the arrow
1
.
›
Insert a new bulb into the holder in the opposite direction to arrow
1
.
The lamp holder for the indicator is provided with the lettering
.
The lamp holder for the reversing lamp is provided with the lettering .
›
Insert the bulb holder into the light » . The holder must engage securely.
CAUTION
■
Before inserting the bulb holder into the light , check that the connector
A
» Fig. 345 is fitted correctly between the light and the bulb holder.
■
Make sure that when refitting the bulb holder into the light, the wiring har-
ness
B
is not pinched - otherwise there is a risk of damage to the electrical
installation.
293
Fuses and light bulbs
Loading ...
Loading ...
Loading ...