Loading ...
Loading ...
Loading ...
Lights and visibility
Light
Introduction
Unless otherwise stated, the lights only work when the ignition is switched on.
For the basic position of the light switch, use the position.
Note
The headlights may mist up temporarily. When the light is switched on, the
light-emitting surface demists after a short period of time.
Operating the lights
Fig. 57
Light switch
To switch on/off the lights, turn the
A
» Fig. 57 switch to one of the follow-
ing positions (equipment-dependent).
Switching off lights (except daytime running lights)
Switching the light on/off automatically » page 70
Switching on the parking lights or parking lights on both sides » page 73
Switching on the low beam
Headlight range control of the Halogen headlights
The headlight range can be set in Infotainment in the menu
/ → →
Light
.
The range of the halogen headlights can be set on the screen, in accordance
with the vehicle load, to the following basic settings.
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
In the event of another vehicle loading condition, the setting for positions . .
can be used.
The Full LEDFront headlights s utomatically adjust to vehicle loading and driv-
ing conditions, so they do not have manual headlight range control.
WARNING
Always adjust the headlight range control to comply with the following
conditions and prevent accidents.
■
The vehicle does not dazzle other road users, especially oncoming vehi-
cles.
■
The beam range is sufficient for safe driving.
Note
■
If, with a dipped beam, the ignition is turned off, then the dipped beam will
automatically switch off and the parking lights will come on. Does not apply to
the position , as long as the conditions are met for the COMING HOME
function . The parking lights are switched off when the ignition key is removed
(for vehicles with the KESSY system, after opening the driver's door).
■
If there is a fault in the light switch, the low beam comes on automatically.
Daytime running lights
The daytime running lights illuminate the area in front of and to the rear of the
vehicle (only applicable for some countries).
The lights are switched on automatically if the following conditions are
met.
The ignition is switched on.
The light switch is in the position
or
.
or: The light switch is in the position , and visibility has not become
worse.
WARNING
Always switch on the low beam when visibility is poor.
69
Lights and visibility
Loading ...
Loading ...
Loading ...