Loading ...
Loading ...
Loading ...
EN-4
► Do not heat up unopened tins or jars of food in the
drawer, as pressure will build up in the tin or jar causing it
to explode. This could result in injury and scalding or
damage.
► The underside of the drawer gets hot when switched on.
Be careful not to touch it when the drawer is open.
► Do not use plastic or aluminium containers.
These melt at high temperatures and could catch fire. Use
only heat-resistant crockery made of glass, porcelain, etc.
► Take care when opening and closing the loaded d rawer,
that liquids do not spill over and get through the vents. This
can cause the appliance to short circuit.
► Bacteria can develop on the food if the temperature is too
low. Make sure that you set a high enough temperature to
keep food warm.
Cleaning and care
► Danger of injury.
Do not use a steam cleaning appliance to clean this
appliance. The steam could reach electrical components
and cause a short circuit.
Caring for the environment
Disposal of the packing material
The transport and protective packing has been selected from
materials which are environmentally friendly for disposal,
and should be recycled.
Ensure that any plastic wrappings, bags, etc. are disposed of
safely and kept out of the reach of babies and young
children. Danger of suffocation.
Disposal of your old appliance
Electrical and electronic appliances often contain materials
which, if handled or disposed of incorrectly, could be
potentially hazardous to human health and to the
environment. They are, however, essential for the correct
functioning of your appliance.
Please do not therefore dispose of it
with your household waste.
Please dispose of it at your local
community waste collection/recycling
centre or contact your dealer for
advice. Please ensure that it presents
no danger to children while being
stored for disposal.
Important information
Electrical connection
The appliance is fitted with a plug and must only be connected to a properly installed earthed socket.
Only a qualified electrician who takes the appropriate regulations into account may install the socket or
replace the connecting cable. If the plug is no longer accessible following installation, an all-pole
isolating switch must be present on the installation side with a contact gap of at least 3 mm. Contact
protection must be ensured by the installation.
Loading ...
Loading ...
Loading ...