Nissan X-Trail 2006

User Manual - Page 639

For NISSAN X-TRAIL 2006 .

PDF File Manual, 1822 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
DTC P0011 IVT CONTROL
EC-639
[QR (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
CONSULT-II Reference Value in Data Monitor Mode BBS001N0
Specification data are reference values.
On Board Diagnosis Logic BBS001N1
The MI will not light up for this diagnosis.
FAIL-SAFE MODE
ECM enters in fail-safe mode when the malfunction is detected.
DTC Confirmation Procedure BBS001N2
CAUTION:
Always drive at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 10V and 16V at
idle.
WITH CONSULT-II
1. Turn ignition switch ON and select “DATA MONITOR” mode with
CONSULT-II.
2. Start engine and warm it up to the normal operating tempera-
ture.
3. Maintain the following conditions for at least 6 consecutive sec-
onds.
Hold the accelerator pedal as steady as possible.
MONITOR ITEM CONDITION SPECIFICATION
INT/V TIM (B1)
Engine: After warming up
Shift lever: P or N (A/T), Neutral
(M/T)
Air conditioner switch: OFF
No load
Idle 5° - 5°CA
2,000 rpm Approx. 0° - 20°CA
INT/V SOL (B1)
Engine: After warming up
Shift lever: P or N (A/T), Neutral
(M/T)
Air conditioner switch: OFF
No load
Idle 0% - 2%
2,000 rpm Approx. 0% - 50%
DTC No.
Trouble diagnosis
name
Detecting condition Possible cause
P0011
0011
Intake valve timing
control performance
There is a gap between angle of target and
phase-control angle degree.
Harness or connectors
(Intake valve timing control solenoid valve
circuit is open or shorted.)
Intake valve timing control solenoid valve
Crankshaft position sensor (POS)
Camshaft position sensor (PHASE)
Accumulation of debris to the signal pick-up
portion of the camshaft
Detected items Engine operating condition in fail-safe mode
Intake valve timing control The signal is not energized to the solenoid valve and the valve control does not function
ENG SPEED
1,200 - 2,000 (A constant rotation is
maintained.)
SEF174Y
Loading ...
Loading ...
Loading ...