Loading ...
Loading ...
Loading ...
EC-1402
[YD (WITH EURO-OBD)]
DTC P2621, P2622 TP SENSOR
6. CHECK THROTTLE POSITION SENSOR
Refer to EC-1745, "
Component Inspection" .
OK or NG
OK >> GO TO 8.
NG >> GO TO 7.
7. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
With CONSULT-II
1. Replace the electric throttle control actuator.
2. Turn ignition switch ON and OFF.
3. Turn ignition switch ON and select “TARGET ETC ANGLE” in
“ACTIVE TEST” mode.
4. Make sure that throttle valve operates correctly.
Without CONSULT-II
1. Replace the electric throttle control actuator.
2. Turn ignition switch ON and OFF.
3. Turn ignition switch ON and OFF, and make sure that throttle
valve operates correctly.
>> INSPECTION END
8. CHECK INTERMITTENT INCIDENT
Refer to EC-1058, "
TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT" .
>> INSPECTION END
Component Inspection BBS002LW
THROTTLE POSITION SENSOR
With CONSULT-II
1. Turn ignition switch OFF.
2. Reconnect harness connectors disconnected.
3. Turn ignition switch ON.
4. Select “TARGET ETC ANGLE” in “ACTIVE TEST” mode, and
select “THRTL SEN” as the monitor item with CONSULT-II.
5. Check indication under the following conditions.
6. If NG, replace electric throttle control actuator.
Removal and Installation BBS002LX
ELECTRIC THROTTLE CONTROL ACTUATOR
Refer to EM-145, "Removal and Installation" .
PBIB3206E
Condition [TARGET ETC ANGLE (deg)] THRTL SEN (V)
0.0 0.33 - 087
84.0 3.35 - 4.55
PBIB3206E
Loading ...
Loading ...
Loading ...