Loading ...
Loading ...
Loading ...
EC-442
[QR (WITH EURO-OBD)]
DTC P2138 APP SENSOR
10. CHECK APP SENSOR
Refer to EC-442, "
Component Inspection" .
OK or NG
OK >> GO TO 12.
NG >> GO TO 11.
11. REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Replace the accelerator pedal assembly.
2. Perform EC-49, "
Accelerator Pedal Released Position Learning" .
3. Perform EC-50, "
Throttle Valve Closed Position Learning" .
4. Perform EC-50, "
Idle Air Volume Learning" .
>> INSPECTION END
12. CHECK INTERMITTENT INCIDENT
Refer to EC-127, "
TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT" .
>> INSPECTION END
Component Inspection BBS001JT
ACCELERATOR PEDAL POSITION SENSOR
1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Check voltage between ECM terminals 106 (APP sensor 1 sig-
nal), 98 (APP sensor 2 signal) and ground under the following
conditions.
4. If NG, replace accelerator pedal assembly and go to the next
step.
5. Perform EC-49, "
Accelerator Pedal Released Position Learning" .
6. Perform EC-50, "
Throttle Valve Closed Position Learning" .
7. Perform EC-50, "
Idle Air Volume Learning" .
Removal and Installation BBS001JU
ACCELERATOR PEDAL
Refer to ACC-2, "ACCELERATOR CONTROL SYSTEM" .
Terminal Accelerator pedal Voltage
106
(Accelerator pedal position
sensor 1)
Fully released 0.5 - 1.0V
Fully depressed 3.9 - 4.7V
98
(Accelerator pedal position
sensor 2)
Fully released 0.15 - 0.6V
Fully depressed 1.95 - 2.4V
MBIB0023E
Loading ...
Loading ...
Loading ...