Loading ...
Loading ...
Loading ...
DTC P0341 CMP SENSOR
EC-1219
[YD (WITH EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
7. CHECK CAMSHAFT (EXHAUST)
Check the following.
● Accumulation of debris to the signal plate of camshaft rear end
● Chipping signal plate of camshaft rear end
OK or NG
OK >> GO TO 8.
NG >> Remove debris and clean the signal plate of camshaft
rear end or replace camshaft.
8. CHECK INTERMITTENT INCIDENT
Refer to EC-1058, "
TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT" .
>> INSPECTION END
Component Inspection BBS00217
CAMSHAFT POSITION SENSOR
1. Loosen the fixing bolt of the sensor.
2. Disconnect camshaft position sensor harness connector.
3. Remove the sensor.
4. Visually check the sensor for chipping.
5. Check resistance as shown in the figure.
6. If NG, replace camshaft position sensor.
Removal and Installation BBS00218
CAMSHAFT POSITION SENSOR
Refer to EM-167, "VACUUM PUMP" .
MBIB0990E
MBIB0647E
Terminal No. (Polarity) Resistance Ω [at 25°C (77°F)]
1 (+) - 2 (-)
Except 0 or ∞3 (+) - 1 (-)
3 (+) - 2 (-)
MBIB1009E
Loading ...
Loading ...
Loading ...