Loading ...
Loading ...
Loading ...
EC-1630
[YD (WITHOUT EURO-OBD)]
DTC P0336 CKP SENSOR
DTC P0336 CKP SENSOR PFP:23731
Description BBS002IU
The crankshaft position (CKP) sensor is located on the cylinder
block rear housing facing the gear teeth (cogs) of the signal plate at
the end of the crankshaft. It detects the fluctuation of the engine rev-
olution.
The sensor consists of a permanent magnet and Hall IC.
When the engine is running, the high and low parts of the teeth
cause the gap with the sensor to change. The changing gap causes
the magnetic field near the sensor to change. Due to the changing
magnetic field, the voltage from the sensor changes. The ECM
receives the voltage signal and detects the fluctuation of the engine
revolution.
CONSULT-II Reference Value in Data Monitor Mode BBS002BA
Specification data are reference values.
On Board Diagnosis Logic BBS002BB
NOTE:
If DTC P0336 is displayed with DTC P0642 or P0643, first perform trouble diagnosis for DTC P0642 or
P0643. Refer to EC-1686, "
DTC P0642, P0643 SENSOR POWER SUPPLY" .
DTC Confirmation Procedure BBS002BC
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select “DATA MONITOR” mode with CONSULT-II.
3. Start engine and let it idle for at least 5 seconds.
If engine could not start, keep ignition switch at START position
for 5 seconds.
4. If DTC is detected, go to EC-1633, "
Diagnostic Procedure" .
WITHOUT CONSULT-II
1. Start engine and let it idle for at least 5 seconds.
If engine could not start, keep ignition switch at START position for 5 seconds.
2. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
3. Perform Diagnostic Test Mode II (Self-diagnostic results) with ECM.
4. If DTC is detected, go to EC-1633, "
Diagnostic Procedure" .
PBIA9644J
MONITOR ITEM CONDITION SPECIFICATION
CKPS·RPM (TDC)
● Run engine and compare CONSULT-II value with the tachometer indi-
cation.
Almost the same speed as the
tachometer indication.
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0336
0336
Crankshaft position sen-
sor circuit range/perfor-
mance
Crankshaft position sensor signal is not in the
normal pattern when engine is running.
● Harness or connectors
(The sensor circuit is open or
shorted.)
● Crankshaft position sensor
● Signal plate
SEF817Y
Loading ...
Loading ...
Loading ...