Loading ...
Loading ...
Loading ...
TROUBLE DIAGNOSIS
EC-113
[QR (WITH EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
*: For QR25DE engine models
NOTE:
Any monitored item that does not match the vehicle being diagnosed is deleted from the display automatically.
DATA MONITOR (SPEC) MODE
Monitored Item
VHCL SPD CUT*
[NON/CUT]
● Indicates the vehicle cruise condition.
NON: Vehicle speed is maintained at the
ASCD set speed.
CUT: Vehicle speed increased to excessively
high compared with the ASCD set speed, and
ASCD operation is cut off.
LO SPEED CUT*
[NON/CUT]
● Indicates the vehicle cruise condition.
NON: Vehicle speed is maintained at the
ASCD set speed.
CUT: Vehicle speed decreased to excessively
low compared with the ASCD set speed, and
ASCD operation is cut off.
AT OD MONITOR
[ON/OFF]
● Indicates [ON/OFF] condition of A/T O/D
according to the input signal from the TCM.
● For M/T models, always “OFF” is
displayed.
AT OD CANCEL
[ON/OFF]
● Indicates [ON/OFF] condition of A/T O/D can-
cel signal sent from the TCM.
● For M/T models, always “OFF” is
displayed.
CRUISE LAMP*
[ON/OFF]
● Indicates [ON/OFF] condition of CRUISE lamp
determined by the ECM according to the input
signals.
SET LAMP*
[ON/OFF]
● Indicates [ON/OFF] condition of SET lamp
determined by the ECM according to the input
signals.
Voltage [V]
● Voltage, frequency, duty cycle or pulse width
measured by the probe.
● Only “#” is displayed if item is
unable to be measured.
● Figures with “#”s are temporary
ones. They are the same figures
as an actual piece of data which
was just previously measured.
Frequency
[msec], [Hz] or [%]
DUTY-HI
DUTY-LOW
PLS WIDTH-HI
PLS WIDTH-LOW
Monitored item
[Unit]
ECM
INPUT
SIGNALS
MAIN
SIG-
NALS
Description Remarks
Monitored item [Unit]
ECM
input
signals
Main
signals
Description Remarks
ENG SPEED [rpm] ×
● Indicates the engine speed computed
from the signals of the crankshaft posi-
tion sensor (POS) and camshaft position
sensor (PHASE).
MAS A/F SE-B1 [V] ××
● The signal voltage of the mass air flow
sensor specification is displayed.
● When engine is running specification
range is indicated.
B/FUEL SCHDL
[msec]
● “Base fuel schedule” indicates the fuel
injection pulse width programmed into
ECM, prior to any learned on board cor-
rection.
● When engine is running specification
range is indicated.
A/F ALPHA-B1 [%] ×
● The mean value of the air-fuel ratio feed-
back correction factor per cycle is indi-
cated.
● When engine is running specification
range is indicated.
● This data also includes the data for the
air-fuel ratio learning control.
Loading ...
Loading ...
Loading ...