Loading ...
Loading ...
Loading ...
DTC P0016 CKP - CMP CORRELATION
EC-1533
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P0016 CKP - CMP CORRELATION PFP:10328
On Board Diagnosis Logic BBS00286
The MI will not light up for this self-diagnosis.
NOTE:
If DTC P0016 is displayed with DTC P0652 or P0653, first perform trouble diagnosis for DTC P0652 or
P0653. Refer to EC-1691, "
DTC P0652, P0653 SENSOR POWER SUPPLY" .
DTC Confirmation Procedure BBS00287
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select “DATA MONITOR” mode with CONSULT-II.
3. Start engine and let it idle for at least 5 seconds.
4. If DTC is detected, go to EC-1533, "
Diagnostic Procedure" .
WITHOUT CONSULT-II
1. Start engine and let it idle for at least 5 seconds.
2. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
3. Perform Diagnostic Test Mode II (Self-diagnostic results) with ECM.
4. If DTC is detected, go to EC-1533, "
Diagnostic Procedure" .
Diagnostic Procedure BBS00288
1. CHECK CAMSHAFT POSITION SENSOR
Refer to EC-1629, "
Component Inspection" .
OK or NG
OK >> GO TO 2.
NG >> Replace camshaft position sensor.
2. CHECK SPROCKET
Visually check for chipping signal plate gear tooth.
OK or NG
OK >> GO TO 3.
NG >> Remove debris and clean the signal plate or replace sprocket.
DTC No.
Trouble diagnosis
name
DTC detecting condition Possible cause
P0016
0016
Crankshaft position -
camshaft position cor-
relation
The correlation between crankshaft position sen-
sor signal and camshaft position sensor signal is
out of the normal range.
● Camshaft position sensor
● Crankshaft position sensor
● Timing chain
● Signal plate
SEF817Y
Loading ...
Loading ...
Loading ...