Loading ...
Loading ...
Loading ...
EC-1046
[YD (WITH EURO-OBD)]
TROUBLE DIAGNOSIS
INSPECTION PROCEDURE
1. Turn ignition switch OFF.
2. Connect CONSULT-II to data link connector, which is located
under the driver side dash panel.
3. Turn ignition switch ON.
4. Touch “START (NISSAN BASED VHCL)”.
5. Touch “ENGINE”.
If “ENGINE” is not indicated, go to GI-35, "
CONSULT-II Data
Link Connector (DLC) Circuit" .
6. Perform each diagnostic test mode according to each service
procedure.
For further information, see the CONSULT-II Operation Manual.
WORK SUPPORT MODE
Work Item
PBIB0376E
BCIA0029E
BCIA0030E
BCIA0031E
WORK ITEM DESCRIPTION USAGE
ENTER INJCTR CALIB DATA
● Injector adjustment value is written onto ECM memory. When performing Injector Adjust-
ment Value Registration.
INJ ADJ VAL CLR
● Injector adjustment value stored in ECM is initialized. Before changing injector adjust-
ment value stored in ECM, it is
recommended to perform this
work item.
Loading ...
Loading ...
Loading ...