Loading ...
Loading ...
Loading ...
EC-1054
[YD (WITH EURO-OBD)]
TROUBLE DIAGNOSIS
CONSULT-II Reference Value in Data Monitor Mode BBS001WT
Remarks:
● Specification data are reference values.
● Specification data are output/input values which are detected or supplied by the ECM at the connector.
* Specification data may not be directly related to their components signals/values/operations.
MONITOR ITEM CONDITION SPECIFICATION
CKPS-RPM (TDC)
● Run engine and compare CONSULT-II value with the tachometer
indication.
Almost the same speed as the
tachometer indication
COOLAN TEMP/S
● Engine: After warming up More than 70°C (158°F)
VHCL SPEED SE
● Turn drive wheels and compare CONSULT-II value with the speed-
ometer indication
Almost the same speed as the
speedometer indication
FUEL TEMP SEN
● Engine: After warming up More than 40°C (104°F)
ACCEL POS SEN*
● Ignition switch: ON
(Engine stopped)
Accelerator pedal: Fully released 0.5 - 1.0V
Accelerator pedal: Fully depressed 4.0 - 4.8V
ACCEL SEN 2*
● Ignition switch: ON
(Engine stopped)
Accelerator pedal: Fully released 0.15 - 0.6V
Accelerator pedal: Fully depressed 1.95 - 2.4V
MAS AIR/FL SE*
● Engine: After warming up
● Air conditioner switch: OFF
● Shift lever: Neutral position
● No load
Ignition switch: ON
(Engine stopped)
Approximately 0.4V
Idle 1.3 - 1.6V
Engine is revving from idle to
about 4,000 rpm.
1.3 - 1.6V to Approximately 4.0V
(Check for liner voltage rise in
response to engine being
increased to about 4,000 rpm)
BATTERY VOLT
● Ignition switch: ON (Engine stopped) 11 - 14V
P/N POSI SW
● Ignition switch: ON
Shift lever: Neutral position ON
Except above OFF
START SIGNAL
● Ignition switch: ON → START → ON OFF → ON → OFF
PW/ST SIGNAL
● Engine: After warming up, idle
the engine
Steering wheel: Not being turned OFF
Steering wheel: Being turned ON
BRAKE SW
● Ignition switch: ON
Brake pedal: Fully released OFF
Brake pedal: Slightly depressed ON
BRAKE SW2
● Ignition switch: ON
Brake pedal and clutch pedal:
Fully released
OFF
Brake pedal and/or clutch pedal:
Slightly depressed
ON
IGN SW
● Ignition switch: ON → OFF ON → OFF
ACT CR PRESS
● Engine: After warming up
● Air conditioner switch: OFF
● Shift lever: Neutral position
● No load
Idle 20 - 30 MPa
2,000 rpm 45 - 55 MPa
MAIN INJ WID
● Engine: After warming up
● Shift lever: Neutral position
● Idle speed
No load 0.68 - 0.78 msec
Blower fan switch: ON
Rear window defogger switch: ON
0.78 - 0.88 msec
GLOW RLY Refer to EC-1403, "
GLOW CONTROL SYSTEM" .
PUMP CURRENT
● Engine: After warming up
● Air conditioner switch: OFF
● Shift lever: Neutral position
● No load
Idle 1,700 - 1,900 mA
2,000 rpm 1,600 - 1,800 mA
Loading ...
Loading ...
Loading ...