Loading ...
Loading ...
Loading ...
DTC P2135 APP SENSOR
EC-1739
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P2135 APP SENSOR PFP:18002
Description BBS002F1
The accelerator pedal position sensor is installed on the upper end
of the accelerator pedal assembly. The sensors detect the accelera-
tor pedal position and sends a signal to the ECM. The ECM uses the
signal to determine the amount of fuel to be injected.
CONSULT-II Reference Value in Data Monitor Mode BBS002F2
Specification data are reference values.
*: These signals are converted by ECM internally. Thus, these differ from ECM terminals voltage.
On Board Diagnosis Logic BBS002F3
The MI will not light up for this self-diagnosis.
NOTE:
● If DTC P2135 is displayed with DTC P0642 or P0643, first perform trouble diagnosis for DTC P0642
or P0643. Refer to EC-1686, "
DTC P0642, P0643 SENSOR POWER SUPPLY" .
● If DTC P2135 is displayed with DTC P0652 or P0653, first perform trouble diagnosis for DTC P0652
or P0653. Refer to EC-1691, "
DTC P0652, P0653 SENSOR POWER SUPPLY" .
DTC Confirmation Procedure BBS002F4
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
PBIB1741E
MONITOR ITEM CONDITION SPECIFICATION
ACCEL POS SEN*
● Ignition switch: ON
(Engine stopped)
Accelerator pedal: Fully released 0.5 - 1.0V
Accelerator pedal: Fully depressed 4.0 - 4.8V
ACCEL SEN 2*
● Ignition switch: ON
(Engine stopped)
Accelerator pedal: Fully released 0.15 - 0.6V
Accelerator pedal: Fully depressed 1.95 - 2.4V
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P2135
2135
Accelerator pedal position
sensor 1, 2 signal correla-
tion
The correlation between APP sensor 1 signal
and APP sensor 2 signal is out of the normal
range.
● Harness or connectors
(The APP sensor circuit is open or
shorted.)
● Accelerator pedal position sensor
(APP sensor 1 and 2)
Loading ...
Loading ...
Loading ...