Loading ...
Loading ...
Loading ...
DTC P0563 BATTERY VOLTAGE
EC-1665
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P0563 BATTERY VOLTAGE PFP:24410
On Board Diagnosis Logic BBS002CF
The MI will not light up for this self-diagnosis.
DTC Confirmation Procedure BBS002CG
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select “DATA MONITOR” mode with CONSULT-II.
3. Start engine and let it idle for at least 35 seconds.
4. If DTC is detected, go to EC-1665, "
Diagnostic Procedure" .
WITHOUT CONSULT-II
1. Start engine and let it idle for at least 35 seconds.
2. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
3. Perform Diagnostic Test Mode II (Self-diagnostic results) with ECM.
4. If DTC is detected, go to EC-1665, "
Diagnostic Procedure" .
Diagnostic Procedure BBS002CH
1. INSPECTION START
Are jumper cables connected for the jump starting?
Yes or No
Yes >> GO TO 3.
No >> GO TO 2.
2. CHECK BATTERY AND ALTERNATOR
Check that the proper type of battery and type of alternator are installed.
Refer to SC-4, "
BATTERY" and SC-13, "CHARGING SYSTEM" .
OK or NG
OK >> GO TO 5.
NG >> Replace with a proper one.
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0563
0563
Battery voltage high
An excessively high voltage from the battery is
sent to ECM.
● Battery
● Battery terminal
● Alternator
● Incorrect jump starting
SEF817Y
Loading ...
Loading ...
Loading ...