Loading ...
Loading ...
Loading ...
EC-1284
[YD (WITH EURO-OBD)]
DTC P0563 BATTERY VOLTAGE
DTC P0563 BATTERY VOLTAGE PFP:24410
On Board Diagnosis Logic BBS0022D
This self-diagnosis has the one trip detection logic.
MI will not light up for this self-diagnosis.
DTC Confirmation Procedure BBS0022E
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select “DATA MONITOR” mode with CONSULT-II.
3. Start engine and let it idle for at least 35 seconds.
4. If DTC is detected, go to EC-1284, "
Diagnostic Procedure" .
WITH GST
Follow the procedure “WITH CONSULT-II” above.
Diagnostic Procedure BBS0022F
1. INSPECTION START
Are jumper cables connected for the jump starting?
Yes or No
Yes >> GO TO 3.
No >> GO TO 2.
2. CHECK BATTERY AND ALTERNATOR
Check that the proper type of battery and type of alternator are installed.
Refer to, SC-4, "
BATTERY" and SC-13, "CHARGING SYSTEM" .
OK or NG
OK >> GO TO 5.
NG >> Replace with a proper one.
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0563
0563
Battery voltage high
An excessively high voltage from the battery is
sent to ECM.
● Battery
● Battery terminal
● Alternator
● Incorrect jump starting
SEF817Y
Loading ...
Loading ...
Loading ...