Loading ...
Loading ...
Loading ...
Instrument Functions
R&S
®
NGP800
79User Manual 5601.5610.02 ─ 04
2. Select "LAN" to set LAN connection.
The R&S NGP800 displays the "LAN" dialog.
Note: The "MAC Address" is fixed.
Figure 6-28: Ethernet settings dialog
3. Set the "DHCP & Auto-IP".
● "ON": Enables DHCP for automatic network parameter distribution and shows
the values of the IP Address. By default, the instrument is configured to use
dynamic configuration and obtain all address information automatically.
● "OFF": If the network does not support dynamic host configuration protocol
(DHCP). The addresses must be set manually.
4. Set the required DHCP mode.
If DHCP mode is set "OFF", the following "Ethernet Settings" are required.
5. Configure the "IP Address", "Subnet Mask" and "Gateway".
The R&S NGP800 displays the IP dialog for configuration.
Figure 6-29: IP dialog
6. Set the required IP addresses for "IP Address", "Subnet Mask" and "Gateway"
7. Select "Set" to confirm the value.
Interfaces
Loading ...
Loading ...
Loading ...