Loading ...
Loading ...
Loading ...
Getting Started
R&S
®
NGP800
19User Manual 5601.5610.02 ─ 04
For safety reasons, the instrument may only be connected to properly installed wall
outlets. Separating the ground is prohibited.
The power cable must be inserted before signal circuits may be connected.
Use only the power cable included in the delivery package. See
"Delivery package"
on page 20.
Before each measurement, measuring cables must be inspected for damage and
replaced if necessary. Damaged or worn components can damage the instrument or
cause injury.
The instrument may be operated only under the operating conditions and in the posi-
tions specified by the manufacturer, without the product's ventilation being obstructed.
If the manufacturer’s specifications are not observed, this can result in electric shock,
fire and/or serious personal injury, and in some cases, death.
Provide adequate airflow
Do not block the air intake at the front and side of the instrument or the exhaust at the
rear. Install the instrument on a location that allows sufficient space for air circulation at
the air intake and exhaust. Recommended spacing to non-heat producing surface is at
least 2.5 inches (63.5 mm) from the ventilation holes.
Applicable local or national safety regulations and rules for the prevention of accidents
must be observed in all work performed.
The instrument is designed for use in the following sectors: Industrial, residential, busi-
ness and commercial areas and small businesses.
The instrument is designed for indoor use only. Before each measurement, you need
to verify at a known source if the instrument functions properly.
To disconnect from the mains, unplug the IEC socket on the back panel.
See
Table 4-1 for the general data on the instrument specification. For more informa-
tion, see the instrument datasheet (P/N: 3609.1927.32).
Table 4-1: General data on instrument specification
General data
Mains nominal voltage 100 VAC to 250 VAC 50 Hz / 60 Hz
Maximum input power 650 W for 2 channels
1125 W for 4 channels
Mains fuses Internal 16 A 250 V IEC 60127-2/7 fast-acting
Not user accessible
Operating temperature range +5 °C to +40 °C
Storage temperature range -20 °C to +70 °C
Humidity noncondensing 5 % to 95 %
Putting into Operation
Loading ...
Loading ...
Loading ...