Loading ...
Loading ...
Loading ...
Remote Control Commands
R&S
®
NGP800
106User Manual 5601.5610.02 ─ 04
TRIGger:CHANnel:DIO<IO>............................................................................................106
TRIGger:CONDition:DIO<IO>..........................................................................................106
TRIGger:DIRection:DIO<IO>...........................................................................................108
TRIGger:LOGic:DIO<IO>................................................................................................108
TRIGger[:ENABle]:DIO<IO>............................................................................................108
TRIGger[:ENABle]:GENeral............................................................................................ 109
TRIGger[:ENABle]:SELect:DIO<IO>.................................................................................109
TRIGger:CHANnel:DIO<IO> <arg0>
Suffix:
<IO>
.
1..8
Parameters:
<channel> NONE | CH1 | CH2 | CH3 | CH4 | ALL
NONE
No channel is set as the trigger channel.
CH1
Ch 1 is set as the trigger channel.
CH2
Ch 2 is set as the trigger channel.
CH3
Ch 3 is set as the trigger channel.
CH4
Ch 4 is set as the trigger channel.
CHALI
All channels are set as the trigger channel.
TRIGger:CONDition:DIO<IO> <arg0>[, <arg1>]
Sets the trigger condition of the specified Digital I/O line.
Suffix:
<IO>
.
1..8
Parameters:
<mode> OUTPut | OVP | FUSE | OTP | OPP | VMODe | CMODe |
VLEVel | ILEVel | ENABle | INHibit | ARB | ARBPoint |
ARBGroup | RAMP | ANINput | STATistics | LOG | PLEVel
OUTPut
Output the selected logic level when the output is turned on at
the selected channel.
OVP
Output the selected logic level when the selected critical event
(OVP) occurs on the selected channel.
FUSE
Output the selected logic level when a fuse tripped event occurs
on the selected channel.
Trigger Commands
Loading ...
Loading ...
Loading ...