Loading ...
Loading ...
Loading ...
Remote Control Commands
R&S
®
NGP800
154User Manual 5601.5610.02 ─ 04
[SOURce:]VOLTage:AINPut:TRIGgered[:STATe ] <arg0>
Sets or queries the trigger condition of the analog input for the selected channel.
Parameters:
<condition> OFF | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8
OFF
There is no DIO pin that has a mode set to Analog In for the
selected channel.
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8
DIO pin/s are enabled with a mode set to Analog In for the
selected channel.
When DIO pin is enabled with Analog In mode, analog input of
the channel assigned to that pin will be enabled when the cor-
rect voltage is applied to the DIO pin.
[SOURce:]VOLTage:AINPut[:STATe] <arg0>[, <Channel list>]
[SOURce:]VOLTage:AINPut[:STATe]? [<Channel list>]
Enables or disables the analog input for the selected channel.
Parameters:
<arg0> 1
Analog input for selected channel is enabled.
0
Analog input for selected channel is disabled.
Parameters for setting and query:
<Channel list> <list>
Example:
VOLT:AINP? (@1)
Queries the analog input state at channel 1.
7.7.4 Adjustment
The CALibration subsystem contains the commands for analog input and channel
adjustment.
CALibration:AINPut:CANCel............................................................................................155
CALibration:AINPut:COUNt?........................................................................................... 155
CALibration:AINPut:DATA............................................................................................... 155
CALibration:AINPut:DATE?............................................................................................. 155
CALibration:AINPut:END................................................................................................ 155
CALibration:AINPut:FACTory:RESTore............................................................................. 155
CALibration:AINPut:SAVE...............................................................................................156
CALibration:AINPut:STARt..............................................................................................156
CALibration:AINPut:STATe?............................................................................................ 156
CALibration:AINPut:UMAX..............................................................................................156
CALibration:AINPut:UMIN............................................................................................... 157
CALibration:CANCel.......................................................................................................157
Advanced Operating Commands
Loading ...
Loading ...
Loading ...