Loading ...
Loading ...
Loading ...
Getting Started
R&S
®
NGP800
27User Manual 5601.5610.02 ─ 04
2. Connect the power cable to the socket outlet.
3. Toggle the power rocker switch at the rear panel to turn on the instrument.
The instrument performs a system check, boots the operating system, and starts
the R&S NGP800 power supply firmware.
It takes a few seconds for the power supply to complete the initialization before it is
ready for use. If the instrument does not turn on, verify that the power cord is securely
plugged-in and power is available at the outlet. Check if the standby power is lit at the
[Power] key on the front panel. If the standby power is lit, press the [Power] key to ini-
tiate the start-up sequence.
To switch off instrument:
1. Press the [Power] key.
The R&S NGP800 power supply initializes the power down sequence and enters
into standby mode. The R&S NGP800 operates at low power.
2. Toggle the rocker switch at the rear panel to turn off the instrument completely.
3. Disconnect the AC power cable from the socket outlet.
4.3 Trying Out the Instrument
This chapter describes some basic functions that you can perform with the
R&S NGP800 power supply series.
4.3.1 Setting the Output Voltage and Current Limit
1.
Press [Home]
key.
The R&S NGP800 power supply displays the home window.
Trying Out the Instrument
Loading ...
Loading ...
Loading ...