Loading ...
Loading ...
Loading ...
Remote Control Commands
R&S
®
NGP800
152User Manual 5601.5610.02 ─ 04
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8
DIO pin/s are enabled with a mode set to arbitrary for the
selected channel.
When DIO pin is enabled with arbitrary mode, QuickArb function
of the channel assigned to that pin will be enabled when the cor-
rect voltage is applied to the DIO pin.
7.7.2 EasyRamp
The VOTage:RAMP subsystem contains the commands for configuring the EasyRamp
function for the output channels.
[SOURce:]VOLTage:RAMP[:STATe]................................................................................. 152
[SOURce:]VOLTage:RAMP:DURation.............................................................................. 152
[SOURce:]VOLTage:RAMP[:STATe] <arg0>[, <Channel list>]
[SOURce:]VOLTage:RAMP[:STATe]? [<Channel list>]
Sets or queries the state of ramp function for the previous selected channel.
Parameters:
<state> 0 | 1
0
EasyRamp function is deactivated.
1
EasyRamp function is activated.
*RST: 0
Parameters for setting and query:
<Channel list> <list>
Example:
INST OUT1
VOLT:RAMP ON
VOLT:RAMP? -> 1
EasyRamp function of Ch1 is activated
Example:
VOLT:RAMP ON, (@1)
VOLT:RAMP? (@1)
Sets and queries the state of ramp function at channel 1.
[SOURce:]VOLTage:RAMP:DURation <New value for voltage>[, <Channel list>]
[SOURce:]VOLTage:RAMP:DURation? [<Channel list>]
Sets or queries the duration of the voltage ramp.
Parameters:
<duration> <numeric value> | MIN | MINimum | MAX | MAXimum | DEF |
DEFault
<numeric value>
Duration of the ramp function in seconds.
Advanced Operating Commands
Loading ...
Loading ...
Loading ...