Loading ...
Loading ...
Loading ...
Checking and refilling levels
and
They light up red
The engine cannot be restarted! Fault in the
AdBlue system.
Contact a specialised workshop
. Have the system
checked there.
It lights up yellow
The AdBlue reserve is low.
Refill AdBlue within the next kilometres (or mil
es) that
are indicated
›››
page 339. SEAT recommends con-
tacting a specialised workshop.
and
They light up yellow
There is a fault in the AdBlue system or unsuitable
AdBlue fluid has been used.
Contact a specialised workshop. Have the syst
em
checked there.
Several warning and control lamps should
light up f
or a f
e
w seconds when the ignition is
s
wit
ched on, signalling that the function is be-
ing verified. They will switch off after a few
seconds.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning lamps on page 88.
Fill AdBlue
®
Fig. 306
AdBlue tank cap.
Operations prior to refilling
P
ark the v
ehicl
e on a fl
at surf
ace and turn off
the ignition. If the vehicle is on a slope or on a
curb, the level indicator may not detect the
refill properly.
If a warning message about AdBlue
®
levels
appears on the dash panel display, fill at
least the minimum amount required (ap-
prox. 5 litres) Only after adding this amount
will the system detect that AdBlue
®
has been
added and you will be able to start the en-
gine again. The maximum amount that can
be refilled is 11 litres.
Fill with a refill bottle
Only use AdBlue
®
that complies with ISO
22241-1. Only use original containers.
●
Open the tank cover
›››
Fig. 306.
●
Unscrew the tank cap by turning it in an an-
ti-clockwise direction.
●
Please observe the manufacturer's instruc-
tions, indicated on the refill bottle.
●
Check the expiry date.
●
Remove the cap of the refill bottle.
●
Insert the neck of the bottle in the tank filler
neck vertically and screw the bottle on by
hand, by turning it in a clockwise direction.
●
Press the refill bottle in the direction of the
filler neck and hold it in this position.
●
Wait until the contents of the refill bottle
have been poured into the AdBlue
®
tank. Do
not compress or break the bottle!
●
Turn the bottle in a counter-clockwise di-
rection and gently pull it upwards
›››
.
●
The AdBlue
®
t
ank is full when no mor
e liquid
comes out of the bottl
e
.
●
Scr
ew on the tank cap in a clockwise direc-
tion until it is tightly closed.
●
Close the fuel tank flap.
Operations before driving
●
After refilling the tank, only switch on the ig-
nition.
●
Leave the ignition on for at least 30 sec-
onds for the system to detect the fluid load.
●
Make sure you wait for at least 30 seconds
before starting the engine!
»
339
Loading ...
Loading ...
Loading ...