User Manual - Page 103

For ATECA 2019.

Loading ...
Loading ...
Loading ...
Opening and closing
Depending on the equipment, the vehicle
may hav
e the K
eyl
ess Access syst
em.
K
eyless Access is a key-free locking and igni-
tion system to unlock and lock the vehicle
without actively using its key. To do this, all
that is required is to have a valid vehicle key in
the detection area where you are attempting
to access the vehicle
››
Fig. 94 and to touch
one of the sensor surfaces on the door han-
dles
››
Fig. 95 or operate the softtouch/han-
dle on the rear lid
››
page 108
››
.
The v
ehicl
e can be unl
ock
ed and l
ocked via
the front doors only. When doing so, the re-
mote control key must be no further than ap-
prox. 1.5 m away from the door handle.
It does not matter where you carry the key,
e.g. in your jacket pocket.
Once the doors have been locked, they can-
not be opened again immediately. This will
enable you to check that the doors are prop-
erly closed.
If you wish you may unlock only the corre-
sponding door or the entire vehicle. The nec-
essary adjustments can be made in vehicles
with a driver information system
››
page 89
››
page 74.
General information
If a valid key is in the proximity of the car,
››
Fig. 94 the Keyless Access locking and
starting system gives the key entry as soon as
one of the sensor surfaces on the door han-
dles is touched or the softtouch/handle on
the rear lid is operated.
The following features are then available
without having to use the vehicle key actively:
Keyless Entry: unlocking the vehicle using
the handles of the front doors or the soft-
touch/handle on the rear lid.
Keyless Exit: locking the vehicle using the
sensor of the driver or passenger door han-
dle.
Easy Open: opening the rear lid moving one
foot below the rear bumper
››
page 111.
Press & Drive: keyless starting of the engine
with the starter button
››
page 243.
The central locking and locking systems op-
erate in the same way as a normal locking
and unlocking system. Only the controls
change.
Unlocking the vehicle is confirmed with a
double flash of the indicator lights; locking by
a single flash.
If the vehicle is locked and then all doors and
the rear lid are closed leaving the last key
used inside the vehicle and none outside, the
vehicle will not lock immediately. All the ve-
hicle's indicator lights will flash four times.
The vehicle will lock after a few seconds if
you do not open any door or the rear lid.
The vehicle will lock again after a few sec-
onds if you unlock the vehicle but fail to open
any door or boot hatch.
Unlocking and opening the doors
(Keyless-Entry)
Grip one of the front door handles. When
you do this, you touch the sensor surface
››
Fig. 95
A
(arrow) of the handle and the
v
ehicl
e unl
ocks.
Open the door
.
On v
ehicles with selective opening or info-
tainment system configuration, pulling the
door handle twice will unlock all doors.
In vehicles without the “Safe” security sys-
tem: closing and locking the doors
(Keyless-Exit)
Switch the ignition off.
Close the driver's door.
Touch (once) the locking sensor surface
››
Fig. 95
B
(arrow) on one of the front door
handl
es. The door that is used must be
cl
osed.
In v
ehicl
es with the “Saf
e” security sys-
tem: closing and locking the doors
(Keyless-Exit)
Switch the ignition off.
Close the driver's door.
»
101
Loading ...
Loading ...
Loading ...