Loading ...
Loading ...
Loading ...
you use a PoE+ switch that is located indoors, you must install a PoE+ Ethernet surge
protector on the cable from the switch to the access point located outdoors.
Note: Model WAX610Y does not provide a power connector, nor requires a power
adapter. You power up this model only by connecting an Ethernet cable to a PoE+
switch.
The access point LAN/PoE+ port supports Ethernet speeds up to 2.5 Gbps. The following
figure shows a NETGEAR MS510TXPP switch, which supports speeds of 2.5 Gbps and
higher and can supply PoE+. To allow for this speed, your Internet connection, modem,
and switch all need to support a speed of 2.5 Gbps. If one of these components supports
only 1 Gbps (which is a common speed), the LAN connection functions also at 1 Gbps.
Figure 8. Set up model WAX610Y with a PoE+ connection to your network
To set up the access point with an Ethernet connection to your network:
1.
Use the latch on the front of the access point to open the cover.
Carefully pull the latch toward you and pull the cover downward so that it slides out
of the enclosure. The LAN/PoE+ port is now accessible.
2. Connect an Ethernet cable to the LAN/PoE+ port on the access point.
3.
If you use a PoE+ switch that is located indoors, install a PoE+ Ethernet surge
protector (not supplied) on the cable from the switch to the access point located
outdoors. The previous figure shows such a setup.
4.
Connect the other end of the Ethernet cable to a port on a PoE+ switch that is
connected to your network and to the Internet.
User Manual29Install the Access Point in Your
Network and Access It for Initial
Configuration
Insight Managed WiFi 6 AX1800 Dual Band Access Point Models WAX610 and WAX610Y
Loading ...
Loading ...
Loading ...