Loading ...
Loading ...
Loading ...
The bottom panel contains the following components:
•
Reset button. You can use the Reset button to restart the access point or to reset
the access point to its factory default settings. To restart the access point, press the
Reset button for about two seconds. Pressing the Reset for 10 seconds or longer
resets the access point to factory default settings.
Note: If you added the access point to a NETGEAR Insight network location, you
must first use the Insight app or Insight Cloud portal to remove the access point from
your Insight network location before the factory default settings function of the Reset
button is available. For more information, see Use the Reset button to reset indoor
model WAX610 on page 170.
•
LAN/PoE+ port. You must use the LAN/PoE+ Gigabit Ethernet RJ-45 LAN port to
connect the access point to a PoE+ switch.
CAUTION: If you use a PoE+ switch that is located indoors, you must use a PoE+
Ethernet surge protector (not supplied) on the cable from the switch to the access
point located outdoors.
The LAN/PoE+ port supports Ethernet speeds up to 2.5 Gbps when connected to
2.5 Gbps equipment. Your Internet connection, modem, and switch all need to
support a speed of 2.5 Gbps. If one of these components supports only 1 Gbps
(which is a common speed), the access point LAN/PoE+ connection functions at 1
Gbps.
For more information about the LAN/PoE+ port connection, see Set up and connect
indoor model WAX610 to your network on page 27.
Product label outdoor model WAX610Y
The product label of the access point shows the QR code, serial number, MAC address,
default WiFi network name (SSID), and network key (password) of the access point.
Figure 6. Product label outdoor model WAX610Y
User Manual22Hardware Overview Outdoor
Model WAX610Y
Insight Managed WiFi 6 AX1800 Dual Band Access Point Models WAX610 and WAX610Y
Loading ...
Loading ...
Loading ...