Loading ...
Loading ...
Loading ...
Figure 7. Set up model WAX610 with a PoE+ connection to your network
To set up the access point with an Ethernet connection to your network:
1. Connect an Ethernet cable to the LAN/PoE+ port on the access point.
2.
Connect the other end of the Ethernet cable to a port on a switch that is connected
to your network and to the Internet.
If you use a PoE+ connection, the port must be a PoE+ port on a PoE+ switch. The
access point requires 802.3at (PoE+) input. For optimal functioning, make sure that
you use an 802.3at (PoE+) switch and not an 802.3af (PoE) switch.
While the access point is starting or in the process of getting an IP address from a
DHCP server (or router functioning as a DHCP server) in your network, the
Power/Cloud LED initially lights solid amber and then blinks amber slowly. After
about two minutes, the Power/Cloud LED turns solid green or solid blue and the
access point is ready for you to perform the initial configuration.
For information about accessing the access point for initial configuration, see Connect
to the access point for initial configuration on page 30.
Set up and connect outdoor model WAX610Y to your
network
This section applies to outdoor model WAX610Y only.
Note: Before you mount the access point at a permanent location outdoors, we
recommend that you configure the access point for your network environment and test
your setup.
Connect the access point to a Power over Ethernet plus (PoE+) switch in your network.
The switch must be connected to a network router that is connected to the Internet. If
User Manual28Install the Access Point in Your
Network and Access It for Initial
Configuration
Insight Managed WiFi 6 AX1800 Dual Band Access Point Models WAX610 and WAX610Y
Loading ...
Loading ...
Loading ...