Loading ...
Loading ...
Loading ...
The pop-up windows closes and the configuration is reset to factory default settings.
When the reset is complete, the access point reboots. This process takes about two
minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset.
For example, do not close the browser, click a link, or load a new page. Do not turn
off the access point. Wait until the access point finishes restarting and the
Power/Cloud LED turns solid green or solid blue.
Enable SNMP and manage the SNMP
settings
You can access the access point over a Simple Network Management Protocol (SNMP)
connection, which allows SNMP network management software such as HP OpenView
to manage the access point by using the SNMPv1 or SNMPv2 protocol. By default, SNMP
is disabled.
To enable SNMP and manage the SNMP settings:
1.
Launch a web browser from a computer that is connected to the same network as
the access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 46.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 31.
The Dashboard page displays.
4. Select Management > Maintenance > Remote Management.
The Remote Management page displays.
User Manual173Manage and Maintain the Access
Point
Insight Managed WiFi 6 AX1800 Dual Band Access Point Models WAX610 and WAX610Y
Loading ...
Loading ...
Loading ...