Loading ...
Loading ...
Loading ...
Remote Control Commands
R&S
®
NGL200/NGM200
131User Manual 1178.8736.02 ─ 09
// ************************************************
// Unlink linked overcurrent protection
// ************************************************
// queries the combined overcurrent protection of the selected channel
CURR:PROT:UNLink 2
CURR:PROT:LINK?2
[SOURce:]CURRent:PROTection:CLEar...........................................................................131
[SOURce:]CURRent:PROTection:DELay:INITial................................................................ 131
[SOURce:]CURRent:PROTection:DELay.......................................................................... 132
[SOURce:]CURRent:PROTection:LINK.............................................................................132
[SOURce:]CURRent:PROTection:TRIPped?..................................................................... 133
[SOURce:]CURRent:PROTection:UNLink......................................................................... 133
[SOURce:]CURRent:PROTection[:STATe].........................................................................133
FUSE:DELay:INITial.......................................................................................................134
FUSE:DELay[:BLOWing]................................................................................................ 134
FUSE:LINK....................................................................................................................135
FUSE:TRIPped?............................................................................................................ 135
FUSE:UNLink................................................................................................................ 135
FUSE[:STATe]................................................................................................................135
[SOURce:]CURRent:PROTection:CLEar [<Channel list>]
Resets the OCP state of the selected channel. If an OCP event has occurred before,
the reset also erases the message on the display.
Setting parameters:
<Channel list> <list>
Example:
CURR:PROT:CLE (@1)
Resets OCP state at channel 1.
Example: See
Example "Configuring the overcurrent protection"
on page 129.
Usage: Setting only
[SOURce:]CURRent:PROTection:DELay:INITial <duration>
[SOURce:]CURRent:PROTection:DELay:INITial? [<Channel list>]
Sets or queries the initial fuse delay time once output turns on.
Parameters:
<duration> <numeric value> | MIN | MINimum | MAX | MAXimum | <list>
<numeric value>
Numeric value for initial fuse delay.
MIN | MINimum
Min value for initial fuse delay.
MAX | MAXimum
Max value for initial fuse delay.
Range: 0.00 to 60.00
Configuration Commands
Loading ...
Loading ...
Loading ...