Loading ...
Loading ...
Loading ...
›
Set the crossbar so that the screws
A
are pointing forward.
›
Place the crossmember with the fixed part
C
onto the left lashing eyelet in
the direction of arrow
2
.
›
Pull out part
D
of the cross member and place onto the right lashing eyelet
in arrow direction
3
.
›
Push the mounts
B
in the direction of arrows
4
until they click» Fig. 119.
›
Turn the screws
A
in the direction of arrow
5
up tothe latch.
›
Check how well the crossmember is fastened by pulling on it.
Removingis carried out in the reverse order.
Fitting/removing the bike rack
Fig. 120
Fitting the bike rack
Read and observe and on page 88 first.
›
Toinstall, loosen screw
A
on the bicycle rack (hereinafter only referred to
as "carrier") in direction of arrow
1
» Fig. 120.
›
Place the carrier of the crossmember in the direction of arrow
2
.
›
Hold part
B
of the carrier firmly and press on part
C
of the support in the
direction of arrow
3
.
›
Remove screw
A
in the direction of arrow
4
.
›
Screw out screw
D
in the direction of arrow
5
and remove.
›
Place part
E
in the direction of arrow
6
, depending on bike size, in one of
the possible positions » .
›
Insert screw
D
and tighten in the direction of arrow
7
.
Removingis carried out in the reverse order.
CAUTION
The bike stowed in the rack must not touch either the boot lid or other vehicle
parts - there is a risk of damage to the vehicle occurring.
Place bicycle into the carrier
Fig. 121
Insert the front fork of the bicycle into the carrier / mounting
example of the front wheel
Read and observe and on page 88 first.
›
Remove the front wheel from the bike.
›
Release the quick release
A
» Fig. 121 on the carrier and adjust according to
the bicycle fork width.
›
Place the bicycle fork on the fixing axle and tighten with the quick release
A
.
›
Set the left bicycle pedal towards the vehicle front to secure the front wheel
more easily.
›
If you want to transport two bicycles, loosen screw
A
» Fig. 120 on page 89
on the carrier and move the carrier along with attached bike to the left.
The handlebar must not touch the side window of the luggage compartment.
›
Tighten screw
A
» Fig. 120 on page 89 on the support.
›
Guide the boot lid gently downwards and check while doing this that there is
no contact between the handlebar and the rear window.
89
Transport of cargo
Loading ...
Loading ...
Loading ...