Loading ...
Loading ...
Loading ...
Lights and visibility
Light
Introduction
The lights work only with the ignition on, unless otherwise stated.
For the basic position of the light switch, use position .
Note
The headlights may mist up temporarily. When the light is on, the light-emit-
ting surface demists after a short time.
Operating the lights
Fig. 54
Light switch and control dial for
headlight range adjustment
Toswitch the lights on/off,turn the
A
» Fig. 54 switch to one of the following
positions (equipment-dependent).
Switching off lights (except daytime running lights)
Switching the light on/off automatically » page 62
Switching on the parking lights or parking lights on both sides » page 64
Switch on low beam
Depending on the vehicle load, adjust the headlight range by turning the con-
troller
B
» Fig. 54 to the following positions.
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
WARNING
Always adjust the headlight beam to meet the following conditions - other-
wise there is a risk of an accident.
■
The vehicle does not dazzle other road users, especially oncoming vehi-
cles.
■
The beam range is sufficient for safe driving.
Note
■
If, with a dipped beam, the ignition is turned off, then the dipped beam will
automatically switch off and the parking lights will come on. Does not apply to
the position , as long as the conditions are met for the COMING HOME
function . The parking lights are switched off when the ignition key is removed
(for vehicles with the start button, after opening the driver's door).
■
If there is a fault in the light switch, the low beam comes on automatically.
Daytime running lights
The daytime running lights (hereinafter only referred to as "function") lights
the front and rear vehicle area (only valid for some countries).
The lights are switched on automatically if the following conditions are
met.
The light switch is in the position
or
.
The ignition is switched on.
The parking aid is activated.
Activating/deactivating function on vehicles with Infotainment
The function can be deactivated/activated in the Infotainment system in menu
→ →
Light
.
Deactivating on vehicles without Infotainment
›
Turn off the ignition, pull the indicator/main beam lever towards the steering
wheel, push down and hold in this position.
›
Switch on the ignition and hold the lever in the above position until an audible
signal sounds (about 3 s).
Activating on vehicles without Infotainment
›
Turn off the ignition, pull the indicator/main beam lever towards the steering
wheel, push up and hold in this position.
›
Switch on the ignition and hold the lever in the above position until an audible
signal sounds (about 3 s)..
61
Lights and visibility
Loading ...
Loading ...
Loading ...