Loading ...
Loading ...
Loading ...
282
To pair the VCMI device with the tablet via BT
1. Power on the tablet.
2. Connect the 26-pin end of the data cable to the VCMI's vehicle data connector.
3 . Connect the 16- pin end of the data cable to the vehicle data link connector
(DLC).
4. Tap VCMI Manager on the MaxiSys Job Menu of the tablet.
5. Select BT, short for Bluetooth, from the connection mode list.
6. Swipe the Bluetooth toggle to turn it ON. Tap Scan at the top-right corner. Now
the device starts searching for available pairing units.
7. Depending on the VCMI type you use, the device name may display as Maxi
suffixed with a serial number. Select the required device for pairing.
8. When paired successfully, the connection status displays as Connected.
9. Wait a few seconds, and the VCMI button on the system Navigation bar at the
bottom of the screen displays a green BT mark, indicating the tablet is
connected to the VCMI device.
10. To disconnect the device, tap the connected device listing again.
11. Tap Back at the bottom of the screen to return to the MaxiSys Job Menu.
NOTE
A VCMI device can be paired to only one tablet at a time, and once it's been paired, the
device will not be discoverable by any other unit.
Update
The Update module provides the latest update for the MaxiSys Ultra EV tablet. Before
updating the VCMI or BAS software, please make sure the tablet network connection is
stable.
Loading ...
Loading ...
Loading ...