Loading ...
Loading ...
Loading ...
220
Set the DC voltage in the waveform generator interface. The waveform generator
can simulate the signals of numerous sensors including the water temperature
sensor, oil pressure sensor, and position sensor and then feed back to the engine
ECU.
Actuator Drive
Figure 9-103 Actuator Drive Connection Diagram
This function can drive 2-wire solenoid valve, solenoid coil , and low-power motor,
including the canister solenoid valve, injector solenoid valve, transmission hydraulic
valve, hydraulic control valve, ignition coil, idle motor, and throttle motor.
It can change the operation speed and working time of the actuator by setting the
frequency and duty cycle. The higher the frequency, the faster the speed, and the
higher the duty cycle, the longer the working time, and vice versa .
NOTE
To avoid damaging the actuator, do not actuate it for a long time, and do not set too
high a frequency.
This function needs to be tested on the car. If the actuator is removed, it cannot be
driven individually.
Loading ...
Loading ...
Loading ...