Loading ...
Loading ...
Loading ...
30
USING THE TABLET
OBD2 Diagnostics
REQUEST CONTROL ON-BOARD SYSTEM - $08
The Request Control On-Board System - $08 allows you perform an EVAP Test or Particulate Filter Regeneration and
Inducement System Reinitialization.
n EVAP Test - lets you initiate a leak test for the vehicle’s EVAP system.
n Particulate Filter Regeneration – this service requests the vehicle to initiate a PF regeneration.
The vehicle manufacturer is responsible to determine the criteria to enable, start and stop the
test, such as engine running, vehicle speed, or engine rpm.
n Inducement System Reinitialization - This service requests the vehicle to initiate a reinitialize
the inducement system. The vehicle manufacturer is responsible to determine the criteria to
enable, start and stop the test, such as engine running, vehicle speed, or engine rpm.
NOTE: The tablet does not perform the leak test, but signals to vehicle’s on-board
computer to initiate the test. The vehicle manufacturer determines the criteria and
method for stopping the test once it has been started. BEFORE using the Request
Control On-Board System function, refer to the vehicle’s service manual to determine
the procedures necessary to stop the test.
NOTE: Some vehicle manufacturers do not allow Tablets or other external devices to
control vehicle systems. If the Request Control On-Board System is not supported by
the vehicle under test, an advisory message displays. Press
Back to return to the
OBD2 Menu.
1. From the OBD2 Menu, select Request Control On-Board System - $08.
n A Request Control On-Board System - $08 screen displays.
NOTE: The EVAP Test use for Spark Ignition, and
the Particulate Filter Regeneration and Inducement
System Reinitialization use for Compression Ignition.
2. Select the test displays on screen, then press OK.
n A “One moment please…” message displays while
the tablet performs the test.
3. When the test has been initiated by the vehicle’s on-board
computer, a conrmation message displays.
DRIVE CYCLE PROCEDURES
A Drive Cycle for a Monitor requires that the vehicle is driven in such a way that all the required “Enabling Criteria”
for the Monitor to run and complete its diagnostic testing are met. You can use the Tablet to view the Drive Cycle
Procedures for a selected Monitor.
1. From OBD2 Menu, select Drive Cycle Procedures, then press OK.
n A “One moment please…” message displays while the Tablet retrieves Monitor status.
Loading ...
Loading ...
Loading ...