Loading ...
Loading ...
Loading ...
184
SYSTEM SETTINGS
Auto Listing
This setting is used to have the activity report that is
stored in the machine's memory printed out at regular
intervals.
You can choose to have the report automatically
printed each time the number of stored transactions
exceeds 50, or have the report printed at a specified
time every day (only once per day). You can also
enable both print methods.
The report is normally set to not print out. To have the
report automatically printed when the number of stored
transactions (the combined total of transmissions and
receptions) exceeds 50, select "Auto Print Rept At
Limit(50)".
To have the report printed at a specified time, enable
"Print Time Set" and enter the desired time.
• The setting is enabled and a checkmark appears in
the checkbox.
• If this procedure is performed when the setting is
enabled, the checkmark will be cleared and the
setting disabled.
Initial Setting
These settings are used to change the default settings
(initially set at the factory) for the various fax functions
to settings that better meet your needs.
Select the [Initial Setting] to configure the settings.
Dial Mode
This setting is used to set the appropriate dial mode for
the line connected to the machine. Select tone for a
tone dial line or pulse for a pulse dial line.
Pause Time
This setting is used to select the duration of pauses
that are inserted in destination fax numbers.
Normally the setting is 2 seconds, which means that
each time the [PAUSE] key is pressed when dialing or
storing a fax number, a pause of 2 seconds is inserted.
The pause time can be set to any number of seconds
from 1 to 15.
Own Passcode Set
Use this setting to setting the fax number of the
machine and the name of the user. The programmed
name and number are printed at the top of each fax
page you send. The number is also used as a
passcode when performing polling reception
"SENDING OPTIONS" (p.100)".
You can check your programmed name and number
by printing out the "List Print" (p.181)
A maximum of 20 digits can be stored for the fax
number.
• A maximum of 18 letters can be stored for the
name.
Set Volume
This setting is used to adjust the on-hook volume, the
ringing volume, the line monitor volume, the TX/RX
end sound volume, the original scanning end sound
volume, and the tone output volume. All volume
settings are initially set to "Middle".
• "High", "Middle" or "Low" can be selected for the on
hook volume.
• "High", "Middle", "Low" or "Off" can be selected for
volumes other than the on hook volume.
• To cancel a "Print Time Set" setting,
select "Cancel":
• Select "Cancel" with the [ ] or [ ] key
and then press the [OK] key.
• If "Auto Print Rept At Limit(50)" is not
enabled and the number of recorded
transactions exceeds 50, each new
transaction will delete the oldest
transaction.
• The activity report can also be printed out
on demand. (See "PRINTING LISTS OF
PROGRAMMED INFORMATION AND
SETTINGS" (p.109).)
Note
To clear the programmed fax number and
name, follow these steps:
(1) Select "Delete" and then press the [OK]
key.
(2) Select "Delete" with the ] or [ ] key
and then press the [OK] key.
Note
Loading ...
Loading ...
Loading ...