Loading ...
Loading ...
Loading ...
Configuration Examples
363
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
Figure 1. 802.1X authentication roles
802.1X Example Configuration
This example shows how to configure the switch so that 802.1X-based authentication is
required on the ports in a corporate conference room (xg1–xg8). These ports are available to
visitors and must be authenticated before access is granted to the network. The
authentication is handled by an external RADIUS server. When the visitor is successfully
authenticated, traffic is automatically assigned to the guest VLAN. This example assumes
that a VLAN was configured with a VLAN ID of 150 and VLAN name of Guest.
1. On the Port Authentication page, select ports xg1 through xg8.
2. From the Port Control menu, select Auto.
The selection from the Port Control menu for all other ports on which authentication is
not needed must be Authorized. When the selection from the Port Control menu is
Authorized, the port is unconditionally put in a force-authorized state and does not
require any authentication. When the selection from the Port Control menu is Auto, the
authenticator PAE sets the controlled port mode.
3. In the Guest VLAN field for ports xg1–xg8, enter 150 to assign these ports to the guest
VLAN.
You can configure additional settings to control access to the network through the ports.
See Configure a Port Security Interface on page 262 for information about the settings.
4. Click the Apply button.
5. On the 802.1X Configuration page, set the port-based authentication state and guest VLAN
mode to Enable, and then click the Apply button. (See Configure Global 802.1X Settings on
page 253.)
This example uses the default values for the port authentication settings, but you can
configure several additional settings. For example, the EAPOL Flood Mode field allows
you to enable the forwarding of EAPoL frames when 802.1X is disabled on the device.
6. On the RADIUS Server Configuration page, configure a RADIUS server with the following
settings:
• Server Address. 192.168.10.23
• Secret Configured. Yes
Loading ...
Loading ...
Loading ...